12
2. Use the or button to change the start
time. (The start times advance in 15 minute
increments.) Hold either button down for 1
second to change times rapidly.
3. Press the button to select the next start
time (up to 9 start times are available).
Eliminating a Start Time
With the display in the watering Start Time
mode, push the or button until you
reach 12:00 AM (midnight). From here push
the button once to reach the OFF position.
NOTE: If the SVC has all 9 start times turned off,
then the controller is off.
Setting the Run Time (Length of Watering)
1. Press the button until the Run Time icon
is displayed.
2. The display will show the last run time
entered.
3. Use the or button to change the
station run time on the display from 1
minute to 4 hours.
Setting Days to Water
1. Push the button until the Water Days
icon is displayed.
2. The controller will display seven days of
the week with a icon or a icon above
the numbered day. The icon would
represent an “On” water day, while the
icon would represent an “Off” watering
day.
Selecting Specic Days of the Week to Water
1. With the cursor on a specic day (the
cursor always starts with 1), press the
button to activate a particular day of
the week to water. Press the button to
cancel watering for that day. After pressing
a button the cursor automatically advances
to the next day.
2. Repeat step 1 until all desired days have
been selected. The selected days will show
with a to indicate their status ON. The last
is the last watering day for the program.
Programming the Controller
The SVC is easy to program. The easy-to-
understand icons and push button design
allows you to step through the process of
programming and activate manual watering
with the press of a button.
The SVC display shows time and day when
the button is pressed. The button allows
you to navigate among programming options.
During a short period of inactivity, the display
will shut off to retain battery power. When
programming, the ashing portion of the
display can be changed by pressing the or
buttons. To change something that is not
ashing, press the or buttons until the
desired eld is ashing.
The SVC allows for up to 9 start times.
Multiple start times permit morning, afternoon
and evening watering, perfect for the
establishment of new lawns and thirsty annual
owers. Simply designate the days of the week
you want to water. The SVC makes it easy.
Setting the Date and Time
1. Press the button until the Current Time/
Day icon is displayed.
2. Hours will be ashing. Press the or
button to change the hour shown on the
display. Press the to proceed to setting
the minutes.
3. Minutes will be ashing. Use the or
button to change the minutes shown on the
display. Press the to proceed to select
AM, PM or 24 hour time.
4. The time will be displayed, and the time of
day ashing. Press the or button to
select AM, PM or 24 hour. Press the to
proceed to setting the day of the week.
5. The icon will appear and the day of the
week will be ashing. Press the or
buttons to select the day of the week (1
through 7) corresponding to the day.
The time and day have now been set.
Setting Watering Start Times
1. Push the button until the Start Times
icon is displayed.
PROGRAMMING THE SVC-100
To Next Page
Loading...
Need help?
General
