34 35
System Off
The system off function will
turn your WVC controller off,
stopping all automatic watering
until turned back on with your
WVP.
To turn the WVC off:
1. Use the button until the off icon is
displayed. After ashing for a few seconds,
the word “OFF” will appear in the display.
2. Squeeze the Transmit/Receive button on
the WVP once to move to communication
mode (lower part of LCD), use the
and buttons to make sure the arrow
is pointed toward the WVC icon, then
squeeze and hold the Transmit/Receive
button on the WVP. The WVP will beep
twice indicating that the “OFF” command
is being sent to the WVC. It will beep
twice again indicating the command was
successfully received by the WVC.
To turn the WVC on:
1. While in the programming mode (upper
part of the LCD), press the button until
the current time and day is displayed.
2. Squeeze the Transmit/Receive button once
to move to communication mode (lower
part of LCD), use the and buttons to
make sure the arrow is pointed toward the
WVC, then squeeze and hold the Transmit/
Receive button on the WVP. The WVP
will beep twice indicating that the “ON”
command has been sent to the WVC. It will
beep twice again indicating the command
was successfully received by the WVC.
Tip: Use the retrieve program function (see
page 33) to identify if WVC has been turned
off in the eld. After retrieving the program, a
controller that has been turned off will display
the system off icon on the WVP display.
Programmable Rain Off
This feature permits the user to
stop all programmed waterings
for a designated period from
1 to 7 days. At the end of the
programmable rain off period,
the controller will resume normal automatic
operation.
1. Press the button until the System Off
icon is displayed.
2. Press the button and a 1 will be
displayed. The 1 will be blinking at this
point.
3. Press the button as many times as
needed to set the number of days off
desired (up to 7).
4. Squeeze the Transmit/Receive button once
to navigate to the communication mode.
5. Use the and buttons to make sure the
arrow is pointed towards the WVC.
6. Squeeze and hold the Transmit/Receive
button. The WVP will beep twice
indicating the command is being sent to the
WVC. It will beep twice again to indicate
that the WVC has received the command.
Battery Life Indicator
The battery life indicator
icon is a quick way to
determine the remaining
life of the battery installed
in either the WVP or any
individual WVC controllers.
The WVP will
continually show the status of its battery while
the Current Time/Day is displayed. The WVP
can also retrieve the battery life information
from the WVC when programs are retrieved
(see Retrieving Programs). A fully charged
battery will show all three segments of the
battery dark. As the battery is expended, the
segments will appear as outlines.
After retrieving battery life information
from the WVC, the icon will display the
information until the WVP LCD goes blank
due to inactivity. The next time the WVP
display comes on it will provide battery life
information for the WVP.
PROGRAMMING THE CONTROLLER (continued)
To Next Page
Loading...
