Hunter TCX56 - Page 7

2.5 Mounting Standard Tire to Rim .................................................................... 40
2.6 Mounting of difficult tires: low profile or Run-Flat tires ............................. 42
2.7 Match Mounting ............................................................................................ 44
2.8 Tire Inflation .................................................................................................. 45
Special procedure .................................................................................. 46
2.9 Removal of Wheel from Tire Changer ........................................................ 48
2.10 Clamping Jaw Extensions AR46N .............................................................. 49
3. Advanced Procedures ......................................................................... 50
3.1 Advanced Bead Breaking Procedures ........................................................ 50
Bead Breaking “AH” Wheels (e.g. BMW M3, M5, Some Porsches, Range
Rover, Lancia, etc.) ................................................................................ 50
Bead Breaking “AH” Wheels as follows: ............................................... 50
3.2 Advanced Demounting Procedures (for TCX56) ......................................... 51
Demounting Tire from Rim Using the Bead Lever Tool without the Plastic
Sleeve Protector .................................................................................... 51
Demounting Upper Bead ...................................................................... 51
Demounting Lower Bead ...................................................................... 51
3.3 Advanced Mounting Procedures ................................................................ 52
3.4 Standard Mount/Demount Head Assembly ............................................... 52
Checking Mount/Demount Head Calibration ........................................ 52
For Steel Heads .................................................................................... 52
Set Position of Steel Mount/Demount Head on Hex Shaft ................... 52
For Plastic Heads .................................................................................. 54
Set Position of Plastic Mount/Demount Head on Hex Shaft ................ 54
Adjust the Offset of Lock Mechanism – Steel and Plastic Heads ......... 55
3.5 Mount/Demount Head Assembly ................................................................. 56
Mount/Demount Head Calibration ......................................................... 56
4. Maintenance ........................................................................................ 60
4.1 Maintenance Schedule ................................................................................. 60
4.2 Maintenance and Replacement Parts ......................................................... 62
5. Glossary ................................................................................................ 63
5.1 Rim Diagram .................................................................................................. 63
5.2 Illustrations of Various Rim Designs ............................................................ 64