CARE
23
Removing the Fabric/Motor/Headrail
Should you need to remove the fabric, motor, and/or headrail, refer to the following instructions.
Remove the Fabric from the Headrail
IMPORTANT: Make sure you have clean hands or wear disposable gloves when handling
Luminette
®
fabric. Select an area in the home where the fabric can be laid flat. To avoid
wrinkling the fabric, do not fold the fabric or drape it over furniture.
■ Traverse the fabric to the fully stacked position.
■ Detach both end treatments from the ends of the headrail, as shown.
■ Remove the fabric from each pinion clip. Hold the top of the vane near the polytab, and pull
down and to the left.
■ Lay the fabric flat on a clean surface with the vanes facing in the same direction.
■ If the original tube is available, gently roll the fabric onto it, making sure the fabric stays
straight. Do not roll the fabric too tightly.
Remove the Modular Motor
■ Unplug the motor’s power cable from the extension cable to
the DC power supply.
■ There are two methods for removing the motor shown on the
following page. Choose the one that works best for you.
and swivel plate by pulling upward
on the end treatment while
holding the swivel plate in place.
Pinion
Clip
To Next Page
Loading...
Need help?
General
