Pre-Installation Manual for i-Series Machines v387 Start-up Preparation 3-3
Service Visit
Schedule an appointment for a Hurco-certified Service Engineer to prepare the machine
for start-up after power is connected by a Certified Electrician.
A Certified Electrician needs to provide power to the machine prior to the service
engineer’s arrival. The Hurco-certified Service Engineer performs these tasks:
1. Checks electrical service to the Main Disconnect switch on the machine.
2. Installs the control console.
3. Measures voltages in the electrical cabinet and the control enclosure.
4. Installs the flood coolant tank and coolant pump motor.
5. Installs covers and enclosures.
6. Completes the machine level and makes required adjustments.
7. .Checks fans and pumps for proper operation
8. Checks all axes for calibration and correct limit switch operation.
9. Installs and tests all options.
Programming Training
Attend a Hurco programming training class for machine operators.
Hurco and full-service distributors offer hands-on training classes to demonstrate the
powerful programming capabilities of its controls. Customers will gain knowledge of the
console and machine by attending training classes.
For additional information or to register for a training class, contact your local Hurco
office or distributor, or go to the Hurco website at www.hurco.com.
To Next Page
Loading...
