nloo
o
0
Crankcase,Crankshaft 0
Removalofcrankcase
The following componentswill havebeen removed
already: chain and bar, centrifugal clutch, ignition
system,carburetor, silencer,cylinder and piston.
Fig 8:3
Separatethe tank unit from the crankcase.
Remove the cylinder basegasket.
Fig 8:1
Drain the oil and fuel tanks.
Placethe chain saw in the clamping device No,
5025102-01 and remove oil pump and tank unit.
Do not forget to disconnectthe oil hosesbetween
crankcaseand oil tank.
Fig 8:4
Remove the sevenscrewsholding the crankcase
halvestogether.
Do not forget the screw behind the plastic cover
on the rear part of the crankcase.
Fig 8:2
Removethe six screws(three on eachside) that
connect the crankcaseto the tank unit.
Fig 8:5
Warm up the bearingseatscarefully with a gas
burner, to abt 130° C. Warming up should be
applied evenly to avoid thermal stress.
Avoid to heat the ball bearingsdirect with the
flame!
8:1
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
