2100
SafetyEquipment
on
A.Chainbrake
Removal
Proceedasfollows:
Remove the clutch cover and clean brake mecha-
nismand brake band.
Fix the clutch cover in the clamping deviceNo.
5025102-01 with two spareguide bar studsand
nuts.
Fig 11:3
Dismantle the brake band asfollows:
Usea drift@ 1 mm to pushout from below the
roll pin that retainsthe brake band in the correct
position, The band with pull rod and springmay
then be changed.
Fig 11:1
Pushthe brake band upwards (e.g. by insertinga
combination key between the brake band and the
two rearsupports) in order to get at the adjusting
nut (seefig. 11:1).
Remove the adjusting nut retaining the pull rod,
and carefully releasethe brake mechanismwith the
hand guard.
Removethe brake spring.
Fig 11:4
When replacing the hand guard, first removethe
nut then the pivot pin.
Fig 11:2
Check the band wear. The band should haveat
least3/4 of its original thickness(1 mm) on its
most worn part, otherwise it must be changed.
Fig 11:5
11:1
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
