(0)
Crankcase,Crankshaft ~
Fig 8:14
Fit a new main bearingsealin the magneto sideof
the crankcase.Usefitting drift No. 5025082-01.
Fit the oil pump (seechapter 6).
Fit piston and cylinder (seechapter 7).
Pressuretest the crankcase(seechapter 2).
Assemblyof
crankcase
— tankunit
Fit the rear part of the tank unit first, so that the
fuel hosemay be pulled through the hole in the
crankcase.
Fig 8:16
Adjust the front part of the tank unit and fit the
vibration dampers.
Changingthevibrationdampers
Fig 8:15
Check the vibration dampersbefore reassembling
the tank unit and the crankcase.
If they are limp or damagedthey should be changed.
Use U-spannerNo. 5025066-01. Make surethat
the tool alsoturns the rear steelwasherof the
damper.
8:4
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
