m
Fig 8:10
Placethe drive side in the clamping device No.
5025102-01. Warm up the bearingseatto abt
130°C. Fit the ball bearing in the seatand locate
it properly with fitting tool No. 5025030-01.
Leavethe crankcasehalf in the clamping device
to cool down.
Fig 8:1 1
Greasethe gasketseatand fit a new gasketon the
magneto side of the crankcase.
Locate the magneto sidewith crankshaft over the
drive side, ensuringthat the gasketisnot displaced.
Turn around the crankcasein the clamping device.
Check that the guide pinsenter correctly.
Crankcase,Crankshaft ~
Fig8:12
Pull the crankcasehalvestogether with fitting
tool No. 5025030-01.
Tighten all screws, beginning nearest the crank-
shaft (see fig. 8:4).
Check the position of the gasketand cut off its
edgeson the cylinder basesurface.
Fig 8:13
Check that the crankshaft rotateseasily. If not,
knock lightly with a plastic hammer on the drive
sideof the crankshaft.
Check that the crankshaft is properly centered in the
crankcase.
8:3
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
