00
CentrifugalClutch 0
Changingthewormgear
The worm gearof the oil pump drive iseasily
removed from the clutch drum. It hasfour dogs
which fit into four correspondinggroovesin the
clutch drum.
Fig 10:4
When fitting a new gear, put it in the clutch drum
and check that it fits exactly into the groovesof
the drum. Then fit the drum with gearon the
crankshaft.
Do not forget the washer behind the worm gear!
Checkingwear
Check the wear of the clutch centre and the clutch
shoes.There should be at least 1 mm material
left on the friction surfaceof the shoes.
Lubrication
Lubricate the worm gearof the oil pump drive
with
Molykote before fitting the clutch drum. The
needle bearing is to be lubricated with ball bearing
grease. Two pumps with
the greasegun into the
hole of the shaft centre are sufficient.
Fig 10:6
Fig 10:5
A{{the shoeshaveto be-changedon thesame
occasion.
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
