2100
00
CentrifugalClutch 0
Removal
Fit the piston stop No. 5025033-01 into the spark
plug hole. Remove the clutch centre with tool No.
5025024-01 or combination wrench. NOTE!
Left-hand threads. Lift off clutch centre and clutch
drum. Do not losethe washerbehind the worm
gear, if the gearfollows the drum.
Usethe drift to pressa new bearing into the clutch
drum. NOTE! Presson the sideof the bearing
where the type number is. Check that the bearing
ison a level with the drum hub.
On Oregon rim sprocket drum the bearingcan be
changedwithout tools.
Changingtheclutchspring
The clutch springshould be changedif it hasbeen
overheated (blue coloured) or broken. it is
easily changedwith pliers No. 5025049-01 as
shown in fig. 10:3.
Fig 10:1
Changingtheneedlebearing
Lift off the worm gearof the oil pump drive if
necessaryand place the clutch drum with the chain
drive upwardson a tube sleeve(e.g. No. 5025 030-04)
ascloseto the bearingaspossible.
Fig 10:3
When fitting the new spring,check that its ends
connect in the centre of a clutch shoe. Do not
overstretchthe spring!
Fig 10:2
Pushout the bearingwith a suitable drift. The
drift isto be centered by the inner diameter of the
bearing (e.g. usea rejected shaft),
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
