English - 13
Pos. Description Used for Order No.
1 Air gap tool, ignition Setting ignition module 514 24 41-01
2 Piston stopper Locking the crank shaft 581 40 85-01
3 Wrench Clutch out or in 513 63 60-01
4 Puller assy Rotor out 510 13 89-01
5 Rod assy Piston pin out or in 521 53 35-01
6 Wrench Clutch spring in 513 63 65-01
7 Guide Brake spring out or in 513 63 70-01
8 Guide Crankshaft in 513 70 59-01
9 Tachometer Engine speed meter 502 71 14-01
10 Torx wrench T20/T25/T27 578 28 90-01
11 Ignition checker Spark strength check 501 97 64-01
12 Guide Setting heating coil (543XPG) 512 41 31-01
13 Spark plug adapter Pressure testing 503 84 40-03
14 Cover plate, inlet Pressure testing 574 71 14-01
15 Rubber wedge, outlet Pressure testing 502 54 11-02
16 Bearing/oil seal, kit MAG side 584 14 05-01
17 Bearing/oil seal, kit PTO side 584 14 05-02
18 Pressure/vacuum gauge Pressure testing 531 03 06-23
19 Compression tester Compression testing 531 03 16-86
19b Adapter Size: 10mm 583 84 98-01
20 Assembly xture Securing the chain saw 502 51 02-01
21 Crankshaft assembly kit Assembling crankshaft 502 50 30-22
(MAG side only)
22 Hook for fuel lter Withdrawing the fuel lter 502 50 83-01
23 Assembly kit, piston Assembling the piston 502 50 70-01
24 Adjustment screwdriver Adjustment of the carburettor 513 63 56-01
25 Adjustment screwdriver Adjustment of the carburettor 530 03 55-60
Service tools
20
19
18
21
22 23
19b
24
25
The tools listed here are
the service tools required
for this model of chain
saw. In addition to these
tools, a normal kit of hand
tools is required.
To Next Page
Loading...
