44 - English
Assembly
1. Fit the tank unit. See gure 47.
2. Fit the earth cables.
3. Fit the stop control cable from the ignition mod-
ule.
4. Fit the hoses B and C and the throttle rod A to
the throttle trigger. See gure 46.
5. Fit the starter, cylinder cover, clutch cover, saw
chain and the guide bar.
7.17 Tank unit
Dismantling
1. Drain the fuel from the tank.
2. Remove the clutch cover, saw chain, guide bar,
starter and the cylinder cover. Remove the rear
handle cover.
3. Detach hoses B and C. Detach the throttle rod
A. See gure 46.
4. Remove the handle bar. Detach the handle
heater (543 XPG). Remove the chain catcher.
5. Detach the cabling from the stop switch and
earth cabling from the crankcase.
6. Detach the cabling from the handle heater
switch (543 XPG) and stop switch (top one)
7. Remove the tank unit. See gure 47.
Repair Instructions
WARNING!
The fuel used in the chain saw has
the following hazardous properties:
1. The fluid and its vapour are poisonous.
2. Can cause skin irritation.
3. Is highly inflammable.
Fig 46
Fig 47
To Next Page
Loading...
