28 - English
Repair Instructions
7.8 Dismantling the ignition module
and flywheel
1
Remove the cylinder cover. Remove the starter.
Snap off the ignition cable from the air guide plate
and remove the air guide plate. See gure 9.
3
use special tool 510 13 89-01 to remove the y-
wheel. See gure 11.
4
Detach the ignition cable and loosen the screws.
See gure 12.
Cleaning and inspection
• Clean all parts, especially the tapers on the
ywheel and shafts.
• Check the ywheel for cracks or any other signs
of damage.
2
Knock out a few of the pins in the tool if it does not
match up with the ywheel.
Use the tool to hold the ywheel in place while the
ywheel nut is loosened using a suitable socket
wrench. See gure 10.
Fig 9
Fig 10
Fig 11
Fig 12
To Next Page
Loading...
