46 - English
1
When replacing the fuel lter, the old fuel lter must
be taken out of the tank unit using special tool
502 50 83-01.
2
Pull out the fuel hose from the tank unit and pull
away the lter A. See gure 50.
3
Fit the new fuel lter and insert the
fuel hose back into the fuel tank.
7.20 Replacing the primer bulb
Dismantle
1. Dismantle the cylinder cover and the air lter.
2. Loosen suction hose C and return hose from
the primer bulb. See gure 51.
3. Snap off the fuel pump from the lter holder.
Assembling
1. Snap the primer bulb in place in the lter
holder. See gure 51.
2. Fit the return and suction hose on the primer
bulb.
3. Fit the air lter and cylinder cover.
7.21 Replacing the fuel hose/return hose
The fuel hose is moulded and can only be removed
from outside of the fuel tank.
Use suitable pliers with a smooth cutting face and
loosen the hose B from the fuel tank. See gure
52.
Replace the return hose when required. Tighten
the fuel hose on the lter side with your ngers.
NOTE!
Fluted pliers may not be used with the fuel
hose. They can cause material damage
resulting in damage to the fuel hose.
Repair Instructions
7.19 Replacing the fuel filter
Fig 51
Fig 50
Fig 52
To Next Page
Loading...
