22 - English
Safety equipment
3
Remove the throttle rod from the throttle trigger,
see arrow in gure 22. Press out the throttle trigger
pin with the help of a punch. Remove the throttle
trigger and the spring. See gure 18.
4
6.9 Dismantling the throttle trigger
lockout, throttle trigger and spring
1
Loosen the screw on the rear handle. Remove the
handle cover. See gure 16.
Cleaning and inspection
• Carefully clean and check all parts. See gure
19. Parts must be replaced if cracked or show
signs of other defects. Always use original
spare parts.
• Check that the spring is intact and retains all its
tension.
Fig 16
2
Detach the spring and remove the throttle trigger
lockout by pulling it upward. See gure 17.
Fig 17
Fig 18
Fig 19
To Next Page
Loading...
