Husqvarna 560XPG - 7.7 Starter Assembly

English - 21
Repair Instructions
WARNING!
Exercise care to ensure the spring does
not fly out and cause personal injury.
Wear protective goggles.
7.6 Replacing a broken return spring
1. Loosen the screw at the centre of the starter
pulley and loosen the screws on the cassette.
Remove the starter pulley with the cassette and
spring.
2. Remove the broken cassette and replace it with
a new one.
3. Tighten the screw at the centre of the starter
pulley, at a tightening torque of 2-3 Nm. Load
the return spring, see “Loading the return
spring”. See also the “Dismantling the starter”
chapter.
7.7 Starter assembly
Position the starter against the crankcase and
tighten the screws at a tightening torque of
3-4 Nm.