English - 31
Repair Instructions
7.21 Dismantling the carburettor
1. Dismantle the cylinder cover and the air filter
2. Loosen the screws, E Unhook the rubber
attachment F on both sides. See Figure 35.
E
F
F
E
Fig 35
3. Loosen the suction hose A and the return hose
B. See figure 34.
D
C
B
A
Fig 34
4. Remove the air filter holder. Let the air filter
holder remain in place in the cabling for the
stop button. Loosen the fuel hose, C Unhook
the throttle cable, D. See figure 34
5. Press down the lug to release the carburettor.
Lift out the carburettor. See figure 36.
Fig 36
NOTE!
Do not use any sharp tools to loosen the
hoses.
NOTE!
The lug on the carburettor is securely
attached to the partition wall.
To Next Page
Loading...
