56 - English
7.51 Assembling
Fit the following parts:
• The piston and cylinder *
• The fuel unit *
• The handle system *
• The muffler *
• The hand guard *
• The bottom of the carburettor *
• The carburettor *
• The flywheel *
• The starter *
• The cylinder cover
• The centrifugal clutch *
• The chain and bar.
• The clutch cover
* See specific instruction.
Repair Instructions
7.52 Replacing the bar bolt
7.52.1 Replacing a bar bolt with intact crankcase
1. Empty the oil tank.
2. Knock in the old bar bolts from the outside so
that they end up in the oil tank.
3. Remove the bolts from the oil tank.
4. Attach a wire to the head of the bar bolt, lower
the wire through the oil tank and out through
the bolt opening in the crankcase. See figure
83.
5. Pull out the bar bolt so that it protrudes from its
opening. See figure 83.
6. Pull out the bar bolt with its nut. Insert a spacer
between the nut and the crankcase. See figure
83.
7. Fill with chain oil.
Fig 83
To Next Page
Loading...
