Husqvarna 560XPG - 7.30 Assembly

English - 39
7.30 Assembly
1. Thread the throttle cables in the connection K as
outlined in figure 55. NOTE! The figure is shown
from underneath.
2. Run the fuel hose C through hole I and hoses B in
hole J. See figure 55. Pull the hoses so that the
collars are on each side of the bottom on the
carburettor compartment.
3. Tighten the chain catcher in place.
4. Press the movement limiter G into position. See
figure 53.
5. Tighten the screws E. See figure 51.
6. Hook on the throttle cable D in the intake bellow.
See figure 50.
7. Fit the tank unit. The two short screws are fitted to
the bottom of the handle bar.
8. Assemble the carburettor as outlined in
“Assembling the carburettor”. Assemble the air
filter and cylinder cover.
Repair Instructions
7.31 Vibration damping system
7.32 Dismantling
1. Dismantle the following parts:
• Bar and chain.
• Cylinder cover.
• Tank unit and handle. See “Dismantling the
tank unit”.
2. Dismantle the spring on the handle bar using a 4
mm Allen key (see figure 57).
3. Dismantle the springs on the tank unit using a
4 mm Allen key (tool 502 50 18-01). See
figure 57.
7.33 Cleaning and inspection
Clean and inspect all parts.
7.34 Assembly
1. Fit the springs on the handle bar using a 4 mm
Allen key (tool 502 50 18-01).
2. Assemble the following parts:
• Tank unit and handle. See “Assembling the
tank unit”.
• Cylinder cover.
• Bar and chain.
Fig 55
H
J
I
K
C
D
B
Fig 54
Fig 56
Fig 57