Husqvarna 560XPG - 7.10 Assembling the Ignition Module and Flywheel

English - 23
Repair Instructions
7.10 Assembling the ignition module
and flywheel
1. Run the cables through the opening in the
crankcase. Screw the earth cable in place. See
figure 11.
2. Fit the cabling to the stop button.
3. Position the cable channel as outlined in figure
10. NOTE! Take care that the cable channel is
positioned correctly under the ignition module
so that the cables are not crushed.
Place the ignition module in position. See figure
13. Do not tighten the screws.
4. Clean the tapers on the flywheel and shafts.
5. Fit the flywheel onto the crankshaft pin. Turn the
flywheel until the key fits into the key slot on the
shaft. See figure 12. Tighten the screw for the
flywheel.
Fig 12
Fig 13
6. Insert the plastic air gap tool, at a thickness of
0.3 +- 0.1 mm, between the lugs on the ignition
module and flywheel. Turn the flywheel so that
the magnets are positioned opposite the
ignition module.
7. Tighten the screws, at a tightening torque of
4.5- 6 Nm. Remove the plastic air gap tool. Fit
the intake system as outlined in “7.14
Assembling the intake system”, the tank unit as
outlined in “7.16 tank unit”, and the air filter as
outlined in “Assembling the carburettor”.
8. Press the ignition lead into the holder on the
partition wall.
9. Then fit:
• The air nozzle
• The guide rail and press the cable in place
• the spark plug hat by unscrewing the piston stop.
• The starter, at a tightening torque of 2.5-3.5 Nm
• The cylinder cover
Fig 11