100 - English
5. REPAIR INSTRUCTIONS
9. Allow the hexagonal hub to cool.
10. Install wheel motor, wheel, hub cap and ESD plug.
The wheel torque should be 10-12 Nm.
11. In some cases the ESD plug may be hard to
remove without damaging it. Damaged plugs must
be replaced.
5.21 Replacing the solar panel (Solar
Hybrid)
1. Fold the solar panel up
2. Switch off the machine using the main switch
3. Disconnect the cable which runs from the keypad
cover
4. Undo the two screws, which hold the large
connector, from the solar panel, two turns is
sufficient
5. Disconnect the connector
6. Remove the clip that holds the gas spring in the
solar panel
7. Unscrew the four screws holding the panel to the
hinge.
8. When reinstalling, ensure that the connector's
catch engages properly, and remember that the
new solar panel is extremely sensitive to knocks
5.22 Installing GSM mod ule
1. Disassemble the body.
2. Undo the display cover (4 screws).
3. Remove the connections for the battery/batteries.
4. Install the SIM card and antenna on the GSM
module.
5. Carefully install the GSM module directly on the
control card through the opening in the display
cover. Ensure that the module's connector is
attached to the middle of the pin on the control
card. Then assemble the module using the
accompanying screws.
6. Connect the battery/batteries to the control card.
7. Connect the service cable and Autocheck to the
mower. Download a new program to the mower to
support the GSM.
8. Set the necessary settings for the SMS feature
under Settings > Safety > SMS from the mower's
menu. See also 1.14 SMS function page 23.
9. Test the SMS feature by selecting SMS test from
the SMS menu.
10. Assemble the display cover and body.
To Next Page
Loading...
Need help?
General
