66 - English
4. AUTOCHECK, SERVICE PROGRAM
4.7 Help menu
The Help function provides information about the
functions available in Autocheck. When a function is
open you can display information either by selecting
Show help from the Help menu or by right clicking
when the cursor is in the window.
4.7.1 About
You can find out the version number of Autocheck by
using the About Autocheck function. When you select
About Autocheck a box is displayed where, among
others, the version number of the program is shown.
4.8 Menus and functions in
Autocheck
Many of the functions available in the service program,
can also be found on the Tool menu on the mower,
(see 2. Special menu functions, page 25). These
functions work in the same way in both programs. The
difference is that it may be easier to access, view and
state information via the computer.
All instructions and all information in this chapter
presuppose that you have an Automower
®
connected
via the service cable to your computer and Autocheck
is running.
The menus and functions provided by the service
program are listed in the table below.
Further information concerning the functions can be
accessed directly in Autocheck by clicking Help on the
menu bar. Then select Show help. You can also
display help by right clicking when a function is open
and the cursor is in the window.
To Next Page
Loading...
Need help?
General
