The screw dimension is Torx 20 when there is no other
information.
Note: Read the section about how to mount screws in
plastic before starting any maintenance. Refer to
To
mount screws in plastic on page 59
.
Note: Always use the recommended torque to mount the
screws. Refer to
Screw fasteners on page 62
.
5.3 Front unit
5.3.1 To remove and install the front top cover
1. Push the STOP button on top of the product.
2. Remove the product from the charging station.
3. Use the jog wheel to select the On/Off-symbol in the
main menu of the display.
4. Make sure that the LED status indicator is not lit.
Note: If the LED status indicator is lit or is flashing in
any color the product is not switched off.
5. Hold the front top cover above the lights and pull it
up.
6. Remove the front top cover.
7. Install in opposite sequence.
1061 - 001 - Repair instructions - 13
To Next Page
Loading...
