5.5 Link arm
5.5.1 To replace the handle
1. Remove the rear unit. Refer to
To remove and install
the rear unit on page 24
.
2. Remove the front top cover. Refer to
To remove and
install the front top cover on page 13
.
3. Remove the front bumper tail. Refer to
To remove
and install the front bumper tail on page 14
.
4. Remove the front body. Refer to
To remove and
install the front body on page 14
.
5. Remove the front upper chassis. Refer to
To remove
and install the front upper chassis on page 15
.
6. Turn the product upside down.
7. Remove the 2 screws (Torx 27) that hold the lower
handle.
8. Remove the lower handle.
9. Remove the 2 screws (Torx 27) for the handle
support.
10. Push the upper handle to the stop position.
11. Remove the upper handle and the handle support.
Note: The upper handle must be in stop position to
be removed.
32 - Repair instructions 1061 - 001 -
To Next Page
Loading...
