Husqvarna AUTOMOWER 435X AWD - 8 Technical Data; 8.1 Technical Data

Every
year
Every
3rd
year
Action Explanation
X
Charge the battery. Always charge the battery fully before winter
storage. If this is not done, the battery may be
rendered useless due to voltage levels drop-
ping too low.
X
Read the service bulletins for potential recom-
mended updates.
Updated service bulletins can be found in Au-
tocheck.
X
Replace the ventilation filters. Refer to To clean and replace ventilation filter
for the front unit on page 23 and To clean or re-
place ventilation filter for the rear unit on page
31 .
X
Open the center console, the front and rear
chassis and replace the sealing strips.
Refer to To replace the sealing strips on page
23 .
6.3 Screw fasteners
All screws are made from stainless material or rustproofed with zinc plating. Article numbers are found in the spare
parts list (IPL).
The tightening torque must be attained, otherwise there is not a satisfactory seal against moisture etc.
Fastener Hardware Tool Tightening
torque (Nm)
Husqvarna Automower
®
435X AWD, Automower
®
535 AWD
Bumpers to body Screw, 5 x 16 mm Torx 20 1.8
Holder charging plate Screw, 5 x 16 mm Torx 20 1.8
Wheel Nut, M16 24 mm socket spanner 18
Holder 3D sensor Screw, Gray, 4 x 14 mm Torx 20 1.0
Communication circuit board Screw, Gray, 4 x 14 mm Torx 20 1.0
Upper chassis to lower chassis Screw, 5 x 16 mm Torx 20 1.8
Circuit board holder Screw, 5 x 16 mm Torx 20 1.8
Joystick Screw, 5 x 16 mm Torx 20 1.8
Wheel motor Screw, 5 x 16 mm Torx 20 1.8
Cutting module into metal Screw, M5 x 16 mm Hex key 4 1.8
Cutting module into plastic Screw, 5 x 16 mm Torx 20 1.8
Holder rear main cable Screw, 5 x 16 mm Torx 20 1.8
Battery cover Screw, M4 x 12 mm Torx 20 1.8
Battery bracket Screw, M4 x 12 mm Torx 20 1.8
Link arm shaft Nut, M8 x 1 mm 13 mm socket spanner 16
Handle, lower to upper Screw, PW4.2 x 18 mm Torx 27 1.8
Handle, support to link arm Screw, PW4.2 x 18 mm Torx 27 1.8
Link arm to switch plate Screw, M5 x 12 mm Torx 27 6
Clamp link arm main cable Screw, MT4 x 16 mm Torx 27 2.3
Pivoting arm Screw, ISO M6 x 51 mm Hex key 4 10
Cable clamp, rear main cable Screw, MT4 x 16 mm Torx 27 1.8
Link arm to front unit Screw, M6 x 25 mm Torx 27 12
Center console to upper chassis Screw, 5 x 16 mm Torx 20 1.8
62 - Service 1061 - 001 -