7 Troubleshooting
7.1 Messages
This chapter will guide how to troubleshoot the product. There are references to menus in the product, but Autocheck
can also be used in many cases.
Note: Refer to the Operator's manual for more information about how to rectify errors.
Messages
Number Message Cause Action
BATTERY
11 Low battery The product cannot find the charging
station.
Break in the guide wire. Check the LED
on the charging station. Refer to
To
troubleshoot the loop signal on page
73
.
Change the position of the guide wire.
Refer to
Installation - Installation of the
guide wire
in the Operator's manual.
Check the installation settings about
how to find the charging station.
The battery is spent. Perform a battery test. Refer to
Autoch-
eck service tool on page 9
.
12 Empty battery Refer to number 11 above Refer to number 11 above
30/66 Battery problem Battery not connected properly, or faul-
ty
Dismantle the product and check that
the battery is properly connected to its
connector. Refer to
To replace the bat-
tery on page 55
.
Wrong type of battery Use only original batteries recommen-
ded by the manufacturer.
The battery is faulty Replace the battery, refer to
To replace
the battery on page 55
.
58 Temporary battery
problem
Wrong type of battery. Use only original batteries recommen-
ded by the manufacturer.
60 Temporary battery
problem
Battery temp sensor defective. Replace the battery. Refer to
To re-
place the battery on page 55
.
Wrong type of battery. Use only original batteries recommen-
ded by the manufacturer.
62 Temporary battery
problem
Battery temp sensor gives low or high
temperature reading.
Make sure that the operating conditions
are within the battery specification. Re-
fer to
Autocheck service tool on page
9
.
64 - Troubleshooting 1061 - 001 -
To Next Page
Loading...
