6 Service
6.1 Servicing tool
Item Description Use for Article number
1 Mandrel To remove the rear body 577 90 66-01
6.2 Service schedule
The table below contains a checklist of points and actions to be taken when servicing the product. Complete service
plans can be found in Autocheck.
Every
year
Every
3rd
year
Action Explanation
X
Remove the body and clean the chassis. Refer to
To remove and install the front body on
page 14
and
To remove and install the rear
body on page 27
.
X
Clean the ultrasonic sensors carefully. Refer to
To replace the ultrasonic sensors on
page 45
.
X
Clean the headlights carefully. (Automower
®
435X AWD)
X
Check the cable to the product's charging
plates. Replace if damaged.
X
Check all rubber grommets into the chassis that
they seal properly. Replace if damaged.
X
Check the cable and cable terminals to the
charging plates in the body.
X
Check the ventilation filters and clean carefully
with a soft brush.
Refer to
To clean and replace ventilation filter
for the front unit on page 23
and
To clean or re-
place ventilation filter for the rear unit on page
31
.
X
Check the tightening torque of screws on the
chassis.
Refer to
Screw fasteners on page 62
.
X
Check the blades and blade screws. Replace if
damaged.
Refer to
Maintenance - Replace the blades.
in
the Operator's manual.
X Clean the charging station.
X
Check and polish the charging plates on the
product and in the charging station.
Polish contact surfaces on both the product and
the charging station with a fine grade emery
cloth.
X Make a complete
Auto test
in Autocheck. Refer to
Auto test on page 10
.
X
Check that docking and charging work correct-
ly.
Refer to
Symptoms during docking on page 71
and
Symptoms during charging on page 72
.
X
Do a
Battery test
in Autocheck and check the
battery condition.
Refer to
Auto test on page 10
.
1061 - 001 - Service - 61
To Next Page
Loading...
