5.8.6 To replace the ultrasonic sensors
1. Remove the front top cover. Refer to
To remove and
install the front top cover on page 13
.
2. Remove the front bumper tail. Refer to
To remove
and install the front bumper tail on page 14
.
3. Remove the front body. Refer to
To remove and
install the front body on page 14
.
4. Remove the cable holder.
5. Turn the front body up side down.
6. Push the plastic clip in and down.
7. Remove the ultrasonic sensors.
8. Install in opposite sequence.
5.8.7 To replace the ultrasonic circuit board
CAUTION: Always protect the product from
electrostatic discharge, ESD, before you start to
work on electrical components.
CAUTION: If the circuit board is to be checked
in order to evaluate the guarantee, it should be
placed in a bag with protection against ESD
(electrostatic discharge).
1. Remove the front top cover. Refer to
To remove and
install the front top cover on page 13
.
2. Remove the front bumper tail. Refer to
To remove
and install the front bumper tail on page 14
.
3. Remove the front body. Refer to
To remove and
install the front body on page 14
.
4. Remove the front upper chassis. Refer to
To remove
and install the front upper chassis on page 15
.
5. Remove the front circuit board bracket. Refer to
To
remove and install the front circuit board bracket on
page 42
.
1061 - 001 - Repair instructions - 45
To Next Page
Loading...
