5.4 Rear unit
5.4.1 To remove and install the rear unit
1. Push the STOP button on top of the product.
2. Remove the product from the charging station.
3. Use the jog wheel to select the On/Off-symbol in the
main menu of the display.
4. Make sure that the LED status indicator is not lit.
Note: If the LED status indicator is lit or is flashing in
any color the product is not switched off.
5. Push a screwdriver through the holes located on the
underside of the link arm to loosen the link arm
cover.
6. Remove the link arm cover.
7. Remove the 2 cable clamp screws (Torx 27).
8. Remove the cable clamp.
24 - Repair instructions 1061 - 001 -
To Next Page
Loading...
