5.9 Wheels and wheel motors
5.9.1 To remove and install the wheels
1. Remove the hub cap.
2. Remove the nut (24 socket spanner) and the
washer.
3. Remove the wheel.
4. Remove the wheel cover (Automower
®
435X AWD).
5. Remove the inside cover with a flat screwdriver.
6. Install in opposite sequence.
5.9.2 To replace the front wheel motors
1. Remove the front top cover. Refer to
To remove and
install the front upper chassis on page 15
.
2. Remove the front bumper tail. Refer to
To remove
and install the front bumper tail on page 14
.
3. Remove the front body. Refer to
To remove and
install the front body on page 14
.
4. Remove the front upper chassis. Refer to
To remove
and install the front upper chassis on page 15
.
5. Remove the front circuit boards holder. Refer to
To
remove and install the front circuit board bracket on
page 42
.
6. Remove the front wheels. Refer to
To remove and
install the wheels on page 52
.
52 - Repair instructions 1061 - 001 -
To Next Page
Loading...
