6. The front body is attached to the chassis at 4
positions. At each position, hold the chassis with one
hand and loosen the front body with a quick and
short pull.
7. Remove the body.
8. Install in opposite sequence.
Note: Make sure that the grommets seal properly
against moisture.
5.3.4 To remove and install the front upper chassis
1. Remove the front top cover. Refer to
To remove and
install the front body on page 14
.
2. Remove the front bumper tail. Refer to
To remove
and install the front bumper tail on page 14
.
3. Remove the front body. Refer to
To remove and
install the front body on page 14
.
4. Pull out the grommets for the link arm main cable
and for the switch cord.
5. Disconnect the link arm main cable and the switch
cord.
6. Bend the HMI lid to loosen the clips.
1061 - 001 - Repair instructions - 15
To Next Page
Loading...
