12. Remove the cutting module.
13. Remove the 3 screws that hold the hight adjustment
motor.
14. Remove the height adjustment motor.
15. Install in opposite sequence.
Note: Replace the sealing strip every time you
assemble the front chassis. Refer to
To replace the
sealing strips on page 23
.
5.7 Main cables
5.7.1 To replace the front main cable
1. Remove the front top cover. Refer to
To remove and
install the front top cover on page 13
.
2. Remove the front bumper tail. Refer to
To remove
and install the front bumper tail on page 14
.
3. Remove the front body. Refer to
To remove and
install the front body on page 14
.
4. Remove the front upper chassis. Refer to
To remove
and install the front upper chassis on page 15
.
1061 - 001 - Repair instructions - 37
To Next Page
Loading...
