5. Disconnect the front main cable from the front motor
control circuit board.
6. Remove the front main cable.
7. Install in opposite sequence.
5.7.2 To replace the link arm main cable
1. Remove the front top cover. Refer to
To remove and
install the front top cover on page 13
.
2. Remove the front bumper tail. Refer to
To remove
and install the front bumper tail on page 14
.
3. Remove the front body. Refer to
To remove and
install the front body on page 14
.
4. Pull out the main cable grommet.
5. Disconnect the main cable.
6. Remove the rear unit. Refer to
To remove and install
the rear unit on page 24
.
7. Turn the product upside down.
8. Remove the switch plate. Refer to
To remove and
install the switch plate on page 33
.
9. Remove the 2 screws (Torx 27) for the clamp.
10. Remove the clamp.
38 - Repair instructions 1061 - 001 -
To Next Page
Loading...
