11. Remove the link arm main cable.
12. Install in opposite sequence.
Note: Make sure that the grommets seal properly
seal properly against moisture.
5.7.3 To replace the rear main cable
1. Remove the rear unit. Refer to
To remove and install
the rear unit on page 24
.
2. Remove the rear body. Refer to
To remove and
install the rear body on page 27
.
3. Remove the rear upper chassis. Refer to
To remove
and install the rear upper chassis on page 29
.
4. Remove the 2 screws on the main cable holder.
5. Remove the main cable holder.
6. Remove the cable holder from the upper chassis.
1061 - 001 - Repair instructions - 39
To Next Page
Loading...
