9. Remove the communication circuit board.
10. Install in opposite sequence.
CAUTION: Make sure to connect the
connector correctly to the communication
circuit board.
5.8.5 To replace the front loop circuit board
CAUTION: Always protect the product from
electrostatic discharge, ESD, before you start to
work on electrical components.
CAUTION: If the circuit board is to be checked
in order to evaluate the guarantee, it should be
placed in a bag with protection against ESD
(electrostatic discharge).
1. Remove the front top cover. Refer to
To remove and
install the front top cover on page 13
.
2. Remove the front bumper tail. Refer to
To remove
and install the front bumper tail on page 14
.
3. Remove the front body. Refer to
To remove and
install the front body on page 14
.
4. Remove the front upper chassis. Refer to
To remove
and install the front upper chassis on page 15
.
5. Remove the front circuit board bracket. Refer to
To
remove and install the front circuit board bracket on
page 42
.
6. Disconnect the CAN cable.
7. Remove the front loop sensor.
8. Install in opposite sequence.
44 - Repair instructions 1061 - 001 -
To Next Page
Loading...
