4. Remove the joysticks.
5. Install in opposite sequence.
5.4.9 To clean or replace ventilation filter for the
rear unit
Note: The ventilation filter must be cleaned regulary and
must be replaced if it is damaged.
1. Remove the rear unit. Refer to
To remove and install
the rear unit on page 24
.
2. Remove the rear body. Refer to
To remove and
install the rear body on page 27
.
3. Remove the 2 screws on the main cable holder.
4. Remove the main cable holder.
5. If the ventilation filter is not damaged.
a) Carefully clean the ventilation filter with a brush.
b) Install the main cable holder.
c) Install in opposite sequence.
6. If the ventilation filter is damaged.
a) Remove the ventilation filter.
b) Clean the mounting surface thoroughly.
c) Attach a new ventilation filter. Make sure that the
ventilation filter is fastened properly.
d) Install the main cable holder.
e) Install in opposite sequence.
1061 - 001 - Repair instructions - 31
To Next Page
Loading...
