Note: Replace the sealing strip every time you
assemble the rear chassis. Refer to
To replace the
sealing strips on page 23
.
Note: Attach a new warranty seal.
CAUTION: Make sure that no cables are
pinched.
5.4.6 To replace the rear bumper head and tail
1. Switch off the product.
2. Turn the product upside down.
3. Remove the 4 screws, 2 for each bumper.
4. Remove the rear bumpers.
5. Install in opposite sequence.
5.4.7 To replace the rear snap locks
1. Remove the rear unit. Refer to
To remove and install
the rear body on page 27
.
2. Remove the rear body. Refer to
To remove and
install the rear body on page 27
.
3. Turn the rear body upside down.
4. Push the snap locks out through the groove.
5. Install the new snap locks.
6. Install in opposite sequence.
5.4.8 To replace the rear joysticks
1. Remove the rear unit. Refer to
To remove and install
the rear unit on page 24
.
2. Remove the rear body. Refer to
To remove and
install the rear body on page 27
.
3. Remove the 8 screws, 2 screws for each joystick.
30 - Repair instructions 1061 - 001 -
To Next Page
Loading...
