12. Remove the front upper chassis.
13. Install in opposite sequence.
CAUTION: Make sure that no cables are
pinched.
Note: Replace the sealing strip every time you
assemble the front chassis.
Note: Attach a new warranty seal.
Note: Make sure that the grommets seal properly
against moisture.
5.3.5 To remove and install the center console
1. Remove the front top cover. Refer to
To remove and
install the front top cover on page 13
.
2. Remove the front bumper tail. Refer to
To remove
and install the front bumper tail on page 14
.
3. Remove the front body. Refer to
To remove and
install the front body on page 14
.
4. Bend the HMI lid to loosen the clips.
5. Remove the HMI lid.
1061 - 001 - Repair instructions - 17
To Next Page
Loading...
