Husqvarna AUTOMOWER 435X AWD - 6.4 Information Messages

9. Remove the wheel motor.
10. Install in opposite sequence.
5.9.4 To replace the wheel brushes
Note: The brush holders prevent dirt to enter the body.
They must be used even if there are no brushes.
1. Remove the front top cover. Refer to To remove and
install the front top cover on page 13 .
2. Remove the rear top cover. Refer to To remove and
install the rear body on page 27 .
3. Remove the wheel brush holders in the front unit.
Lift the clips on the wheel brush holder and push
forward.
2
1
4. Remove the front wheel brushes.
5. Install the new wheel brushes.
6. Remove the wheel brush holders in the rear unit. Lift
the clips of the wheel brush holders and push
forward.
2
1
54 - Repair instructions 1061 - 001 -