Husqvarna AUTOMOWER 435X AWD - Page 58

3. Disconnect all cables from the charging station.
4. Remove the 2 screws on the front of the charging
station.
5. Carefully lift the charging cover forward and upward
from the charging tower.
A B
6. Disconnect the charging cable and the cable to the
stop button.
7. Remove the 4 screws from underneath the
baseplate to remove the charging tower.
8. Disconnect the cables to the cable plate.
9. Remove the charging tower from the baseplate.
10. Install in opposite sequence.
5.11.2 To replace the contact plates in the charging
station
1. Remove the charging tower and charging station
cap. Refer to To remove and install the charging
station and the charging station cap on page 57 .
2. Remove the 2 screws and washers for the contact
plates.
3. Remove the contact plates (A) and the springs (B).
A
B
4. Remove the grommet and thread the cables through
the hole.
58 - Repair instructions 1061 - 001 -