2. If the mowing results are not satisfying, the cutting
time can be adjusted to mow for a longer time
(High)
or for a shorter time
(Low)
3.16.2 ECO mode
The ECO mode function automatically turns off the
signal in the boundary loop, the guide wires and the
charging station when the robotic lawnmower is not
mowing. ECO mode is suitable to use where there is
other wireless equipment not compatible with the robotic
lawnmower, for example some hearing loops or garage
doors. When ECO mode is activated, the indicator lamp
in the charging station flashes green.
ECO mode means that the robotic lawnmower can only
be started in the charging station and not out in the
working area. In ECO mode, it is therefore very
important to always press the STOP button on top of the
robotic lawnmower, before removing the robotic
lawnmower from the charging station. It is otherwise not
possible to start the robotic lawnmower inside the
working area. If the lawnmower has been removed by
mistake without first pressing the STOP button, the
lawnmower must be placed back in the charging station
and the STOP button pressed. Then press the START
button to be able to start inside the working area.
Note: In ECO mode, always press the STOP button
before removing the robotic lawnmower from the
charging station.
1. Tap the On/Off bar to enable/disable ECO mode.
3.16.3 Spiral cutting
Intensity
Very Low
Low
High
Very high
Use Spiral cutting
Mid
If the robotic lawnmower enters an area where it senses
the grass is longer than average, it can change the
movement pattern to spiral cutting. This means that the
robotic lawnmower mows in a spiral pattern to faster cut
the area with longer grass. It is possible to set the
intensity of the spiral cutting.
Very low / Low
intensity
means that spiral cutting begins less often.
High / Very
high
intensity means that spiral cutting begins more
often.
Note: In order to minimize the risk for lawn wear in steep
slopes, spiral cutting does not start in slopes steeper
than 15%.
1. Tap the On/Off bar to enable/disable
Spiral cutting
.
2. The intensity can be adjusted to trigger on a shorter
or longer grass length. Choose an appropriate
intensity level by tapping on
Very low, Low, Medium,
High
or
Very high
.
3.17 Installation
INSTALLATION
Find charging station
Lawn coverage
Corridor width
Exit angles
Reversing distance
Drive past wire
The default settings are selected in a way that should
suit most working areas. However, complex gardens
may require changed settings.
3.17.1 Finding the charging station
The robotic lawnmower can be set to search for the
charging station in one or more of the following three
ways:
1. Charging station signal
2. Follow boundary wire
3. Follow guide wire
The default settings are set so that these 3 search
options are combined to find the charging station as fast
as possible, but also with a minimum risk of tracks
forming on the lawn. The robotic lawnmower always
starts by searching for the
Charging station signal
. After
a specified time delay, it also uses
Follow guide
and
Follow boundary wire
.
Common causes why the robotic lawnmower cannot
follow the wire are:
• Obstacles close to the wire have not been isolated.
362 - 002 - 06.02.2018 Installation - 27
To Next Page
Loading...
