6.4 LED indicator lamp on the charging station
For a fully functional installation, the indicator lamp in the charging station must emit a solid or flashing green light. If
any other colour than green is visible, follow the troubleshooting guide below.
There is more help on www.husqvarna.com. If you still need help, please contact your local Husqvarna
representative.
Light Cause Action
Solid green light
Good signals No action required
Green flashing light
The signals are good and
ECO mode
is acti-
vated.
No action required. For more information on
ECO mode
, see
ECO mode on page 27
.
Blue flashing light
The boundary loop is not connected to the
charging station.
Check that the boundary wire connectors are
fitted properly to the charging station. See
Connecting the boundary wire on page 19
.
Break in the boundary loop. Find out where the break is. Replace the
damaged section of the loop with a new loop
wire and splice using an original coupler.
Red flashing light
Interruption in the charging station’s antenna. Contact your local Husqvarna representative.
Solid red light
Fault in the circuit board or incorrect power
supply in the charging station. The fault
should be rectified by an authorized service
technician.
Contact your local Husqvarna representative.
6.5 LED indicator lamp on the robotic lawnmower
There is a LED indicator lamp on top of the robotic lawnmower, which shows the current status:
Light
Cause Action
Solid green light
The robotic lawnmower is either mowing the
lawn, or leaving the charging station.
No action required.
Solid blue light
The robotic lawnmower is either paused or
parked, or is searching for the charging sta-
tion.
No action required.
Solid yellow light
The STOP button has been pressed. Press the START button on top of the robotic
lawnmower to start it again.
Solid red light
The robotic lawnmower has stopped due to a
fatal error.
Clear the error by pressing the STOP button,
and then activate the robotic lawnmower by
pressing the START button on top of the ro-
botic lawnmower.
Flashing yellow light
The robotic lawnmower requests the PIN
code.
The PIN code needs to be confirmed in the
Automower
®
Connect app before the robotic
lawnmower can be activated.
There is more help on www.husqvarna.com. If you still need help, please contact your local Husqvarna
representative.
50 - Troubleshooting 362 - 002 - 06.02.2018
To Next Page
Loading...
