Message Cause Action
Trapped
The robotic lawnmower has got caught in
something.
Free the robotic lawnmower and rectify the
reason for it becoming trapped.
The robotic lawnmower is stuck behind a
number of obstacles.
Check if there are any obstacles which make
it hard for the robotic lawnmower to move on
from this location.
Outside working area
The boundary wire connections to the charg-
ing station are crossed.
Check that the boundary wire is connected
correctly.
The boundary wire is too close to the edge of
the working area.
Check that the boundary wire has been laid
according to the instructions. See
Boundary
wire on page 14
.
The working area slopes too much by the
boundary loop.
The boundary wire is laid in the wrong direc-
tion around an island.
Disturbances from metal objects (fences, re-
inforcement steel) or buried cables close by.
Try moving the boundary wire.
The robotic lawnmower finds it hard to distin-
guish the signal from another robotic lawn-
mower installation close by.
Place the robotic lawnmower in the charging
station and generate a new loop signal, see
Security on page 30
.
Empty battery
The robotic lawnmower cannot find the charg-
ing station.
Check that the charging station and the guide
wire are installed in accordance with the in-
structions. See
Installation of the guide wire
on page 19
.
The guide wire is broken or not connected. Find out where the break is and rectify it.
The battery is spent. Replace the battery. See
Battery on page 44
.
The charging station’s antenna is defective. Check if the indicator lamp in the charging
station flashes red. See
LED indicator lamp
on the charging station on page 50
.
Wrong PIN code
Wrong PIN code has been entered. Five at-
tempts are permitted, and the keypad is then
blocked for five minutes.
Enter the correct PIN code. Contact your lo-
cal Husqvarna representative if you forget the
PIN code.
No drive
The robotic lawnmower has got caught in
something.
Free the robotic lawnmower and rectify the
reason for the lack of drive. If it is due to wet
grass, wait until the lawn has dried before us-
ing the robotic lawnmower.
The working area includes a steep slope. Maximum guaranteed slope is 45%. Steeper
slopes should be isolated. See
Slopes on
page 17
.
The guide wire is not laid at an angle on a
slope.
If the guide wire is laid on a slope, it must be
laid at an angle across the slope. See
Instal-
lation of the guide wire on page 19
.
Wheel motor overloa-
ded, right
The robotic lawnmower has got caught in
something.
Free the robotic lawnmower and rectify the
reason for the lack of drive. If it is due to wet
grass, wait until the lawn has dried before us-
ing the robotic lawnmower.
Wheel motor overloa-
ded, left
46 - Troubleshooting 362 - 002 - 06.02.2018
To Next Page
Loading...
