Husqvarna T525 - Maintenance; Maintenance Schedule

English – 17
Safety equipment
5
Tighten the chain brake by using the saw’s front
hand guard as a tool. Align the front section of the
clutch cover with the front hand guard. Then pull
the front hand guard back to disengage the brake.
See Figure 9
Fig 9
Assemble the following parts:
• Guide bar.
• Saw chain.
• Clutch cover.
6.4 Assembling the muer
1
Attach the muer to the cylinder with the two screws
as outlined in Figure 11.
2
Attach the pump cover, cylinder cover and clutch
cover. See Figure 10.
WARNING!
Do not touch the muer before it
has cooled down. Risk of burns.
6.3. Dismantling the muer
1
Release the brake by moving the front hand guard
backwards.
Loosen the bar nut and remove the clutch cover,
saw chain and bar. See Figure 10.
Fig 10
Fig 11
2
Remove the cylinder cover. See Figure 10.
3
Remove the pump cover. See Figure 10
Cleaning and checking
• Clean and check all components carefully.
Parts must be replaced if cracked or show
signs of other defects.
• Always use original spare parts. The spark
arrestor mesh is best cleaned with a wire brush.
The mesh must be replaced if it is damaged.
The saw will overheat if the mesh is clogged
resulting in damage to the cylinder.
• Never use a saw with a muer in bad condition.
4
Loosen the screws holding the muer to the cylin-
der and remove the muer. See gure 11.