56 – English
Repair instructions
NOTE!
Take care to prevent any dirt and foreign
particles from entering the crankcase.
5
Place the guide pin in the crankcase half of the
ywheel. Fit the 577 70 16-01 assembling tool to
the crankshaft journal. See Figure 89.
6
Put the crankshaft in position and t the other
crankcase half. Apply liquid gasket between the
surfaces of the crankcase. See Figure 90.
7
Screw in the three screws. Tighten them
alternately. Tightening torque of 7-9 Nm.
Note! Remove the protective sleeve from the
crankshaft journal after assembling the crankcase
halves.
8
Assemble the chain saw by following the steps in
the chapter 7.24 Dismantling the piston and the
cylinder in the reverse order. Make sure to use the
correct torque. See Service data.
Fig 89
Fig 90
To Next Page
Loading...
