Husqvarna T525 - Replacing the Crankshaft Bearing and Sealing Ring

English – 55
Repair instructions
4
Carry out the same steps as in step 3 for the
second crankcase half. See Figure 88.
7.28 Replacing the crankshaft bearing
and sealing ring
1
Use the 576 66 64-01 (A), 576 95 45-01 (F) and
725 23 80-51 (E) tools to assemble the crankcase
bearing (B) and sealing ring. Fit the service tool as
outlined in Figure 85. Tighten with a suitable socket
spanner until the roller bearing snaps in place.
Note! These tools are included in mounting kit 577
71 44-01 and can not be ordered separately.
2
Carry out the same steps as in step 1 for the
second crankcase half. See Figure 86.
3
Use the 576 66 64-01 (A), 576 95 56-02 (G) and
725 23 80-51 (E) tools to assemble the sealing ring
(C). Fit the service tool as outlined in Figure 87.
Tighten with a suitable socket spanner as far as
possible.
B
F
E
A
A
E
G
C
Fig 85
Fig 86
Fig 87
Fig 88