Husqvarna T525 - Component Checks and Lubrication; Examine Cutting Equipment

26 – English
7.7 Dismantling the ignition module
and ywheel
1
Dismantle the following:
• Remove the cylinder cover.
• Detach the spark plug cable.
• Remove spark plug
• Remove the starter and air guide rail.
• Remove the ywheel cover
2
Remove the spark plug cap and spark plug. See
Figure 11 .
Fig 14
5
Remove the ignition module. See Figure 14.
Fig 12
3
Grip the spring with a pliers and pull the ignition
cable out through the spark plug cap. see Figure 12.
Pour a little soap and water in the spark plug cap to
facilitate this step..
Fig 11
Repair instructions
Fig 13
4
Detach the cables on the ignition module. See
Figure 13.