Husqvarna T525 - Adjustments, Cooling System, and Troubleshooting; Engine Does Not Start

English – 27
Repair instructions
Cleaning and checking
• Clean all parts, especially the tapers on the
ywheel and axle.
• Check the ywheel for cracks and any other
damage.
7
Knock out a few of the pins in the tool if it does
not match up with the ywheel. Press against the
ywheel while the ywheel nut is loosened using a
suitable socket spanner. See gure 15.
Fig 15
8
Screw the mandrel on the crank shaft journal.
Screw in until 1-2 threads are left on the ywheel.
Knock on the mandrel with a suitable metal
hammer while at the same time pulling the ywheel
outward until the it comes o the shaft. See Figure
16. Then remove the mandrel.
Fig 16
Fig 17