Husqvarna T525 - Dismantling the Piston and Cylinder

48 – English
7.24 Dismantling the piston and cylinder
1
Dismantle the following:
• Air lter cover and air lter
• Carburetor
• Starter assembly
• Clutch cover
• Cylinder cover
• Muer
• Engine case cover
• Front Handle
• Handle
• Rear and bottom anitvibration elements
• Spark plug
See Figure 65.
Fig 65
Fig 66
2
Remove the two screws and remove the ignition
module. See Figure 66.
Fig 67
3
Insert the piston stop 575 29 36-01. Use a 13 mm
socket spanner to remove the clutch. See Figure
67.
Repair instructions